Oven - How to replace the fan motor (2)

Soluzione

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF BURNS

Before any repair or maintenance operation make sure the appliance is not hot.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE FAN MOTOR

1. Disconnect the appliance from the power supply and open the door. (The door MUST remain open during the whole repair).

2. Unscrew the five Torx 20 screws on either side of the top panel and the middle back of the top panel. Lift the top panel from the back to remove.

3. Discharge the capacitor. NOTE: The capacitor must be discharged prior to any repairs.

4. Unscrew the four Torx 20 screws at the top of the back panel and pull the back panel towards you to release the back panel.

5. Carefully disconnect wiring connectors from the fan motor spade. (Note: Take a photo of the wiring positioning/location before disconnecting) Be careful not to damage the connectors.

6. Unscrew the four Torx 20 screws and remove the fan cover inside the oven.

7. Unscrew the 10mm nut on the fan blade.

8. Pull the fan blade towards you to remove.

9. Use a flat bladed screwdriver to lever out the retaining clip holding the fan motor in place.

10. Twist the fan motor counterclockwise to release and remove the fan motor.

11. When reassembling, repeat steps in reverse order.