How to replace oven lamp, side

Soluzione

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF BURNS

Before any repair or maintenance operation make sure the appliance is not hot.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

How to replace oven lamp, side

1. Pull the front of the side grid out first and then unhook from the back to unhook the side grid.

2. Use a small flat bladed screwdriver to carefully lever the glass out of position to release.

3. Lift out the bulb from the oven lamp housing

4. Use a small flat bladed screwdriver to carefully unhook the securing tabs for the lamp housing and then pull the housing to release and remove.

5. Slide up the protective sleeve and then carefully disconnect the wiring connector from the oven lamp spade. (Note: Take a photo of the wiring positioning/location before disconnecting) Be careful not to damage the connector.

6. Carefully disconnect the earth wiring connector from the oven lamp spade. (Note: Take a photo of the wiring positioning/location before disconnecting) Be careful not to damage the connector.

7. Remove the oven lamp housing. When assembling, repeat steps in reverse order.